|Home||» Products||» Tensile Testing Equipment||» Corrosion Resistance Tester|
Corrosion Resistance Tester
- Unit of Measure
Corrosion Resistance Tester
download: Corrosion Resistance Tester.PDF
Corrosion Resistance Tester adapted to the surface treatment of various materials, including paint, electroplating, organic and inorganic coating, anode processing, antirust oil and so on, after these anti-corrosive treatment to test the corrosion resistance of their products.suitable for parts, electronic components, metal materials, protective coatings and industrial products.
|Internal Size (L×W×H)||600x400x450mm|
|External Size (L×W×H)||1070x600×1180mm|
|Equipment Material||Both inside & outside shell adopt P.V.C rigid plastic board|
|Temperature Range||Room temperature ~ 55℃|
|Spraying method||Continuous and Periodic spray type|
|Test Chamber Temperature||Salt Spray Method (NSS ACSS)35±1℃|
|Corrosion-resistant Testing Method (CASS) 50±1℃|
|Saturated air Barrel Temperature||Salt Spray Method (NSS ACSS)47±1℃|
|Corrosion-resistant Testing Method (CASS) 63±1℃|
|Spray Quantity||1.0~2.0 ml / 80cm2 / hr|
|PH value||Salt Spray Method (NSS ACSS6.5~7.2)|
|Corrosion-resistant Testing Method(CASS)3.0~3.2|
|Brine Tank Capacity||25L|
|Multiple Safety Protection Devices||Current discharge protection, over pressure protection, over temperature protection, over load fuse protection|
|Accessories||Testing Salt/ Measuring tank/Nozzle Equipment x 1 set|
|Air source||1HP Air pump (provided by buyer)|
GB / T2423.17-2008 salt spray test method
GB / T 2423.18-2000 "basic procedures for electric and electronic products Test Ka"
GB / T10125-1997 Corrosion tests in artificial atmospheres - salt spray test _
GB10593.2-1990 electric and electronic products environmental parameters measurements
GB / T1765-1979 Determination of resistance to heat, salt spray, weather resistance (artificial acceleration) of the film test
GB / T1771-2007 Paints and varnishes - Determination of resistance to neutral salt spray
GB / T12967.3-2008 auminum and anodized aluminum alloy film detection method
GB / T5170.8-2008 and IEC, MIL, DIN, ASTM and other standards equivalent to
1, Durable hard 8 mm PVC construction, anti-corrosion and easy to clean.
2, Reservoirs with mixing system on stand.
3, Separate heating system apart from salt testing chamber to ensure accurate result and protect circuit.
4, Exposure zone lined with corrosion-resistant PVC sheets.
5, Clear cover allows viewing of test conditions.
6, Peaked cover prevents dripping of condensation onto samples.
7, Water seal and water level protection system.
8, Heated humidifying tower with air relief valve, adjustable tower tip to orient salt fog.
9, Automatic DI water fills to humidifying tower.
10, Digital temperature control.
11, Integral over-protection on heaters.
12, Low water cut-off protection on humidifying tower.