Corrosion Resistance Tester

Being a trustworthy manufacturer and supplier of Corrosion Resistance Tester, that is requested and appreciated for its quality and durability. The offered range of machine is adjusted to the surface treatment of different materials, including paint, electroplating, natural and inorganic covering, anode handling, anti-rust oil etc. after these against destructive treatment to test the consumption resistance of their items. This is tested and verified on various quality parameter to meet client requirement as per set industry standard. Besides, our team of experts dispatch consignment of Corrosion Resistance Tester on time for timely delivery.

Standard Parameters :

Product Features :

• Durable hard 8 mm PVC construction, anti-corrosion and easy to clean.
• Reservoirs with mixing system on stand.
• Separate heating system apart from salt testing chamber to ensure accurate result and protect circuit.
• Exposure zone lined with corrosion-resistant PVC sheets.
• Clear cover allows viewing of test conditions.
• Peaked cover prevents dripping of condensation onto samples.
• Water seal and water level protection system.
• Heated humidifying tower with air relief valve, adjustable tower tip to orient salt fog.
• Automatic DI water fills to humidifying tower.
• Digital temperature control.
• Integral over-protection on heaters.
• Low water cut-off protection on humidifying tower.

Method of operation

• The salt spray chamber internal parts: tower spray device, funnel, rod, V-type sample holder installed.
• Connected to the gas supply, the power is turned on, turn on the power switch.
• In the pressure tank and cabinets add water, two low level light exterminate stop adding water, at the water seal groove seal.
• Purified water and sodium chloride salt in a ratio of 1:20 with a good. The solution was poured into the reagent with a good entrance (low saline to exterminate a lamp).
• We can open all the lamps burn out operation, spray, time switch, switch demisting before opening end of the test.
• According to the test requirements for equipment and cycles for continuous spraying mode (continuous spray T1, T2 tables are all set to 0, T1 is set to intermittent spray working time, T2 is time to rest).

Precautions :

• Regular cleaning and maintenance of salt spray chamber pressure tank, brine tank nozzle.
• Do not pressure sodium chloride solution from the barrel manually add water poured out, the first transfer solution within the cylinder and then further cleaned with distilled water.
• Do not test the exhaust pipe behind the blockage, in order to avoid too much pressure to make the cabinets housing deformation.
• Do not put inflammable and explosive materials inside.
• Salt spray chamber behind the pressure gauge is 2 kg, 1 kg in front, factory in Wuhan still test test Equipment Co., Ltd. has designed, do not tamper with.
• 6, spray amount is less than set the spray tower to increase, reduce excessive spray spray tower (spray amount collected standard is 1 ~ 2ml / h, takes in 16-hour average)

Other Details :